Inspector Tester C - 3rd Shift
Waukesha , Wisconsin
October 23, 2017
Eaton has an opening for an Inspector Tester on 3rd shift. The Inspector Tester on 3rd shift will be located in Waukesha, WI (Badger Drive Location) 
Primary Responsibility: 
Perform assembly inspection of transformers/regulators at various locations in the assembly plants per established procedures.  Perform electrical testing on assembled single and three phase transformers/regulators per established procedures.  Monitor conformance to quality standards.
Essential Functions:
  • Perform routine factory dielectric tests per established procedures, including OX (induced), QC impulse, and hipot (applied potential).
  • Perform routine factory loss tests per established procedures, including load loss (winding loss) & no-load loss (core loss).
  • Perform power factor, ratio, and resistance tests per established procedures.
  • Perform operational test on regulators as required.
  • Perform continuity test on unit per established procedures.
  • Following routine tests, inspect unit nameplate, stamp impedance value on nameplate, and secure nameplate to tested unit.
  • Perform visual inspection on interior of unit upon completion of testing.
  • Perform minor maintenance of test equipment.
  • Perform special routine tests when required.
  • Perform all responsibilities of the Inspector, including, but not limited to:
  • Performing visual inspection of units throughout the assembly process per established procedures.
  • Performing the following tests as required per established procedures:  ratio, resistance, leak, continuity, control box, insulation resistance, regulator sub-assembly, regulator modification, regulator run-in.
  • Applying decals and stencils to exterior of unit and perform paint mileage check as required.
  • Assisting Engineering and Manufacturing in identifying and resolving shop floor problems.
  • Completing various company forms to communicate inspection status and other information and to document inspection results per established procedures.
  • Collecting various types of data per established procedures as required


Basic Qualifications:
  • High school graduate or GED equivalent from an accredited institution
  •  Minimum of 1 year of experience with AC/DC fundamentals or equivalent education.                                                                                                 
  •  Must be able to work in the US without company sponsorship.
  •  Relocation benefits not included. Only candidates living within 50 miles of Waukesha WI will be considered.

Eaton is a power management company with 2016 sales of $19.7 billion. We provide energy-efficient solutions that help our customers effectively manage electrical, hydraulic and mechanical power more efficiently, safely and sustainably. Eaton is dedicated to improving the quality of life and the environment through the use of power management technologies and services. Eaton has approximately 95,000 employees and sells products to customers in more than 175 countries. For more information, visit At Eaton we see things differently. We see opportunities to innovate, go above and beyond, and we work hard because what we do reflects who we are. If you see things differently – if you’re determined, motivated and focused on improving the world around you – then it’s time to see where a career at Eaton can take you. For more information visit www.

Job: Manufacturing & Operations

Region: North America – US/Puerto Rico
Organization: ESSG CPSD PDD Power Delivery Division

Job Level: Entry Level
Schedule: Full-time
Is remote work (i.e. working from home or another Eaton facility) allowed for this position?: No
Does this position offer relocation?: No
Travel: No

A little about us:
Eaton is a global technology leader in power management solutions. We make power operate more efficiently, effectively, safely & sustainably.

Know someone who would be interested in this job? Share it with your network.